Skip to content

Flight Sim Joystick and Throttle Desk Mount

  • by

Finally decided to take this project on !

I have a TM Warthog setup, and some years ago bought the very nice Virpil base.

So it’s time to plasma cut a sexy metal mount for it.

If there’s enough interest I can make a few !

It’s designed around using a 50mm SHS steel tube. Cheap, super stiff and if you want a different length, just cut a new piece. It also means the design is adjustable for angle to suit various configurations and setbacks.

The diagram below shows the small plate for the flight control, and the larger plate is for the TM throttle system.

Leave a Reply

Your email address will not be published. Required fields are marked *